bnoplwk2
Utana kutattam, az XF86-3.3.3 doksija szerint a "XF86_SVGA" server az. Amit ir rola:
2. Notes

On the NV1/STG2000, the driver does not support the virtual desktop features
of xfree86. This is because the NV1 does not have the necessary hardware to
support this feature. If you want to change resolutions, you will have to
modify your config file. Comment out all but the mode you wish to use.
The generic VGA16 server will not work with the NV1. For this reason
XF86Setup cannot be used to configure the server for NV1 based cards. Use
xf86config instead. Select `Diamond Edge 3D' as your board, and select only
ONE mode for each of 8bpp and 16bpp. Do not select a virtual desktop. Also,
make sure you don't select a RAMDAC or clock chip. This does not apply if you
own a Riva128 or RIVA TNT card, as the VGA16 server works just fine on that.
Both the NV1 and the Riva128 only support a 555 RGB Weight in 16 bpp, the
hardware does not do 565. If you run into problems with some window
managers in 16bpp, try putting a Weight 555 in the Display section.
24 bpp is not supported.
In some modes the hardware cursor gets out of sync with the display. Use
Option "sw_cursor" to work around this problem.
There are modelines that confuse the Riva128 chip. This results in a greenish
display. Slightly modifying the modeline usually fixes the problem. In most
cases all that is needed is to reduce the HTotal. You can use xvidtune to do
that.
The low maximum dot clocks for the Riva 128 have been fixed. The driver
should now utilize the Riva 128 to its full capabilitie