von Rypp
2016.05.13
|
|
0 0
67836
|
A bordcomputer szoftverét (nem a térkép CD/DVD!!!). 2 éve ugyan ez volt nekem is. Világért sem akart menni a monitor, aztán végső elkeseredettségemben újraraktam a firmware-t és hibátlan lett.
Neten keress rá a firmware-re. Mk hanyas (I, II, III, IV?) navid van? Mk I-III-ig azt hiszem jó a 3/63-as firmware Mk IV-hez már mehet a 4/00-as verzió. Kiírod CD-re és követed a lenti leírást:
- Open the driver’s door, this must stay open during the entire procedure.
- Put your key in position 1.
- Remove Map DVD from trunk computer.
- Insert burned software CD/DVD.
- Small delay (maybe 30 seconds) then update screen with progress bar.
- Let the computer think; leave your door open. Installation should take between two and six minutes, depending on which computer you’re using.
- When it’s done, it will say “Software Successfully Loaded”.
- Remove software CD/DVD from trunk, replace maps disc.
- Confirm your update by pressing “OK” with the right button.
- The system will now reboot with your new software.
|
Előzmény: getto's (67828)
|
|